Torque Converter Nuts Installation Note
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Align the holes by turning torque converter.
- Insert a screwdriver from the starter installation hole, and lock the drive plate.CAUTION:
- Loosely and equally tighten the torque converter nuts, then further tighten them to the specified tightening torque.
- Tighten the torque converter mounting nuts.
Tightening torque
34-44 N.m (3.5-4.4 kgf.m, 25-32 ft.lb)