No. 4 Engine Mount Installation Note

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Verify that the No. 4 engine mount bracket is installed as shown.
Lightly tighten bolt D.

Fig 1: Verifying The No. 4 Engine Mount Bracket Is Installed
Courtesy of MAZDA MOTORS CORP.
Set the transaxle on a garage jack and lift it.
Align the hole of the No. 4 engine mount bracket with the stud bolts of transaxle.
Lightly tighten bolt A and nuts B, C.
Tighten nuts B, C in the order of B, C, then bolt A.

Fig 2: Lifting Transaxle On A Garage Jack
Courtesy of MAZDA MOTORS CORP.
Tighten bolt D.
Tightening torque

A, B, C: 66.6-93.1 N.m

(6.8-9.4 kgf.m, 49.2-68.6 ft.lb)

D: 85.3-116.6 N.m

(8.7-11.8 kgf.m, 62.9-85.9 ft.lb)

Fig 3: Locating Bolts On No. 4 Engine Mount Bracket
Courtesy of MAZDA MOTORS CORP.