No. 1 Engine Mount Installation Note

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Align the hole of the No. 1 engine mount rubber with the bolt hole of the transaxle.
Lightly tighten bolt A, then tighten bolts B, C.
Tighten bolt A.
Tightening torque

66.6-93.1 N.m

(6.8-9.4 kgf.m, 49.2-68.6 ft.lb)

Fig 1: Tightening No. 1 Engine Mount Bolts
Courtesy of MAZDA MOTORS CORP.