No.1 Engine Mount and No.4 Engine Mount Bracket Installation Note
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the engine mount rubber is installed as shown.
- By aligning the holes with the stud bolts, install the No.4 engine mount bracket to the transaxle.
- By aligning the holes with the stud bolts, install the No.1 engine mount to the transaxle.
- Align the hole of the No.4 engine mount bracket with the No.4 engine mount rubber on the vehicle, and lightly tighten bolt D.
- Lightly tighten nuts A, B, C.
- Tighten nuts A, B, C in the order of B-->C-->A.
- Tighten bolt D.
Tightening Torque
A, B, C: 66.6-93.1 N.m
(6.8-9.4 kgf.m, 49.2-68.6 ft.lb)
D: 85.3-116.6 N.m
(8.7-11.8 kgf.m, 62.9-85.9 ft.lb)
- Tighten bolt E to the No.1 engine mount.
Tightening Torque
E: 85.3-116.6 N.m
(8.7-11.8 kgf.m, 62.9-85.9 ft.lb)
- Remove the SST (49 E017 5A0).