No. 1 Engine Mount Installation Note
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Align the hole of the No. 1 engine mount rubber with the bolt hole of transaxle.
- Lightly tighten bolt A, then tighten bolts B and C.
- Tighten bolt A.
Tightening torque
66.6 -93.1 N.m
(6.8-9.4 kgf.m, 49.2-68.6 ft. lb)
Courtesy of MAZDA MOTORS CORP.