Clutch Pipe Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- A common reservoir is used for the clutch and brake system fluid.
- If clutch pipes have been disconnected any time during the procedure, add clutch fluid (brake fluid), bleed the air, and inspect for leakage after the procedure has been completed.
- Remove the clutch pipe using the SST (49 0259 77OB). Install the clutch pipe using torque wrench SST combination. (See TORQUE FORMULAS .)