LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Security System And Locks System) >> Liftgate Outer Handle Removal/Installation [5HB, WGN]

Liftgate Outer Handle Removal/Installation [5HB, WGN]

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the liftgate upper trim.
  3. Remove the liftgate side trim.
  4. Remove the liftgate lower trim.
  5. Remove the rear finisher.
  6. Remove in the order indicated in Fig 1.
    Fig 1: Removal Order Of Liftgate Outer Handle - (5HB, WGN)
    G01026843Courtesy of MAZDA MOTORS CORP.
  7. Install in the reverse order of removal.
Fig 2: Removing/Installing Liftgate Outer Handle - (5HB, WGN)
G01026844Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals