LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Engine Mechanical [Lubrication System]) >> Oil Pan Removal/Installation >> AJ

Oil Pan Removal/Installation: AJ

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the under cover.
  3. Drain the engine oil. (See ENGINE OIL REPLACEMENT .)
  4. Remove the TWC (RH). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [AJ] .)
  5. Remove in the order indicated in the illustration. See Fig 1.
  6. Install in the reverse order of removal.
  7. Refill the engine oil with the specified type and amount. (See ENGINE OIL REPLACEMENT .)
  8. Start the engine and inspect for oil leakage.
    • If the oil leaks, specify the faulty part and repair or replace it.
  9. Inspect the oil level. (See ENGINE OIL REPLACEMENT .)
    Fig 1: Removing/Installing Oil Pan (AJ)
    G01027521Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals