Air Cleaner Case Installation Note
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Before assembling the air cleaner, verify that the rubber mounts have not fallen off from the air cleaner bracket (3 locations).
- Always install the air cleaner case using the following procedure.
NOTE:
- When inserting the rubber mounts into the air cleaner case, soapy water can be applied.
- Verify that the rubber mounts are set in the air cleaner bracket (3 locations).
- Install the projections on the frame side (2 locations).
- Verify that the projections on the frame side are installed securely.
- Install the projection on the engine side (remaining location).
- Verify that the projection on the engine side installed securely.