No. 3 ENGINE JOINT BRACKET REMOVAL NOTE
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine hanger (RH). (See ENGINE HANGER INSTALLATION NOTE .)
- Using the bolts part number 99794 1025
or M10 x 1.25, length 25 mm {0.984 in}
to Install the SST
as shown (LH Bank).
Tightening torque
100-125 N.m {10.2-12.7 kgf.m, 73.8-92.1 ft.lbf}
- Suspend the engine using the SSTs.
- Remove the No. 3 engine joint bracket.