LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Engine Mechanical (Service Information AJ)) >> Engine Tune-Up >> Engine Tune-Up Preparation

Engine Tune-Up Preparation

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn off the electrical loads.
  2. Warm up the engine as follows.
    1. Start the engine.
    2. Maintain the engine speed 2,500-3,000 RPM  until the cooling fans start to operate.
    3. Release the accelerator pedal.
    4. Wait until the cooling fans stop.
  3. Connect the SST  (WDS or equivalent) to the DLC-2.
Fig 1: Locating Data Link Connector
G01052358Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals