Power Steering Fluid Cooler Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

Raise the vehicle.
Remove the nuts.

Fig 1: Removing Power Steering Fluid Cooler Nuts
Courtesy of MAZDA MOTORS CORP.
Loosen the clamp and disconnect the hose.
1. Drain the fluid into a suitable container.
Fig 2: Disconnecting Power Steering Fluid Cooler Hose
Courtesy of MAZDA MOTORS CORP.
Loosen the clamp, disconnect the hose and remove the cooler.

Fig 3: Removing Power Steering Fluid Cooler
Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.
Fill, purge and leak check the system.