Seat Weight Sensor: Installation
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
Install seat weight sensor on slide adjusters and temporarily tighten four nuts. Tighten nuts "A" (both right and left) at same time to specification. See Fig 1 . See TORQUE SPECIFICATIONS . Tighten nuts "B" (both right and left) at the same time to the specified tightening torque. Install the seat under bracket to the seat weight sensor and temporarily tighten four nuts. Tighten nuts "C" (both right and left) at same time to specification. Tighten nuts "D" (both right and left) at the same time to the specified tightening torque. Reassemble and install front seat.