LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Air Bag System) >> Diagnostic Tests >> Test S: Right Side Curtain Air Bag Module Circuit Resistance High Or Low, Short To Ground Or Short To Power >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Open or short circuit in wiring harness between right side curtain air bag module and SAS control module, right side curtain air bag module malfunction or SAS control module malfunction.

  1. Inspect right side curtain air bag module

    Using scan tool, inspect resistance for PID/DATA monitor PS-CURTN. See PID/DATA MONITOR & RECORD  under DIAGNOSTICS. If resistance is 1.4-3.2 ohms and performing present malfunction diagnosis, replace SAS control module. See SAS CONTROL MODULE  under REMOVAL & INSTALLATION. If resistance is 1.4-3.2 ohms and performing past malfunction diagnosis, test is complete. If resistance is not 1.4-3.2 ohms, go to next step.

  2. Inspect right side curtain air bag module connector

    Turn ignition switch to LOCK position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove right lower B-pillar trim panel. Disconnect and inspect right side curtain air bag module connector. If right side curtain air bag module connector is cracked or chipped, replace wiring harness. If right side curtain air bag module connector is not cracked or chipped, go to next step.

  3. Isolate malfunction

    Connect leads of 2 ohm resistor across terminals of right side curtain air bag module 2-pin connector. Connect negative battery cable. Turn ignition switch to ON position. Using scan tool, inspect PID/DATA monitor OD-P-CURT. If PID readings are normal, replace right side curtain air bag module. See SIDE CURTAIN AIR BAG MODULE  under REMOVAL & INSTALLATION. If PID readings are not normal, replace wiring harness and go to next step.

  4. Inspect SAS control module

    Turn ignition switch to LOCK position. Disable air bag system. Connect right side curtain air bag module connector. Connect negative battery cable. Retrieve Diagnostic Trouble Codes (DTCs). See RETRIEVING DIAGNOSTIC TROUBLE CODES (DTCS)  under DIAGNOSTICS. If DTCs B2777, B2778, B2779 or B2780 are retrieved and performing present malfunction diagnosis, replace SAS control module. If DTCs B2777, B2778, B2779 or B2780 are retrieved and performing past present malfunction diagnosis, test is complete. If DTCs B2777, B2778, B2779 or B2780 are not retrieved, test is complete.
scientia non olet · About LEMON Manuals