LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Front Suspension System) >> Wheel Hub (4X4) Removal/Installation

Wheel Hub (4X4) Removal/Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Mazda B4000, 2004 Mazda B3000, 2004 Mazda B2300, 2003 Mazda B4000, and 2003 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

  1. Removal Note

    Remove the front disc brake DISC & DRUM .
  2. Remove and discard the nut and washer assembly.
    CAUTION: Do not use a hammer to separate the outboard CV joint from the hub. Damage to the outboard CV threads and to internal components may result.
  3. Using the special tool, separate the outboard CV joint from the hub.
  4. Remove the dust shield.
  5. Remove the bolt and detach the anti-lock sensor from the wheel hub.
    CAUTION: Do not overextend the CV joint and boots when removing the hub and bearing assembly.
  6. Remove the bolts (3) and the wheel hub.

  7. Installation Note

    To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals