Front Lower Arm (Rear) Inspection

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the lower arm (rear) from the vehicle.
Inspect for damage, cracks, and bending.
Inspect the ball joint rotation torque.
- Rotate the ball joint five times.
- Measure the rotation torque using a suitable Allen socket and a torque wrench. If not within the specification, replace the lower arm component.
- Rotation torque 8.86-19.6 inch lbs. (1.00-2.22 N.m).

Fig 1: Inspecting Front Lower Arm (Rear)

Courtesy of MAZDA MOTORS CORP.