LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fwd Axle Shafts) >> Removal & Installation >> Intermediate Shaft (2.3L) >> Removal >> Tie-Rod End Ball Joint Removal Note

Tie-Rod End Ball Joint Removal Note

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tie-rod nut.
  2. Separate the tie-rod end from the steering knuckle using the Ball Joint Puller Set (49-T028-3A0). See Figure .
scientia non olet · About LEMON Manuals