LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fwd Axle Shafts) >> Removal & Installation >> Axle Shaft (3.0L) >> Installation >> Axle Shaft (Left Side) Installation Note

Axle Shaft (Left Side) Installation Note

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert the axle shaft into the wheel hub. See Figure .
  2. Apply ATF to the oil seal lip.
  3. Push the axle shaft into the transaxle.
    CAUTION: The sharp edges of the axle shaft can slice or puncture the oil seal. Be careful when installing the axle shaft to the transaxle. The oil seals are damaged easily if this procedure is not done correctly.
  4. After installation, pull the transaxle side outer ring forward to confirm that the axle shaft is securely held by the clip.
scientia non olet · About LEMON Manuals