LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fwd Axle Shafts) >> Overhaul >> Intermediate Shaft (2.3L) >> Reassembly >> Dust Seal (Differential Side) Assembly Note

Dust Seal (Differential Side) Assembly Note

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply grease to the new dust seal lip.
  2. Install the new dust seal (differential side) using a steel plate and the Bearing Installer (49-W027-003) and Support Block (49-S231-626). See Fig 1 .
Fig 1: Assembling Dust Seal (Differential Side)
G00318691Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals