LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fwd Axle Shafts) >> Overhaul >> Axle Shaft (A/T) >> Reassembly >> Tripod Joint, Snap Ring Assembly Note

Tripod Joint, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not damage the roller.

Align the marks and install the tripod joint using a bar and a hammer. See Fig 1 . Install the new snap ring using a snap-ring pliers.

CAUTION: Install the snap ring in the shaft groove securely.
Fig 1: Assembling Tripod Joint
G00310659Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals