LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fwd Axle Shafts) >> Overhaul >> Axle Shaft (A/T) >> Reassembly >> Outer Ring Assembly Note

Outer Ring Assembly Note

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fill the outer ring and boot (transaxle side) with the specified grease. Use the specified grease supplied in the boot kit. The correct amount is 7.06-7.76 oz. (0.209-0.229L).
    CAUTION: Do not touch grease with your hand. Apply it from the tube to prevent foreign matter from entering the boot.
  2. Install the outer ring.
  3. Set the axle shaft to the standard length. See AXLE SHAFT STANDARD LENGTH (TRIPOD TYPE)  table.
    AXLE SHAFT STANDARD LENGTH (TRIPOD TYPE)

    Application In. (mm)
    2.3L
    Left Side 26.45-26.93 (674.1-684.1)
    Right Side 24.72-25.21 (630.4-640.4)
    3.0L
    Left Side 25.28-25.67 (642.1-652.1)
    Right Side 23.52-23.91 (597.4-607.4)
  4. Release any trapped air from the boots by carefully lifting up the small end of each boot with a cloth wrapped screwdriver. See Fig 1 .
    CAUTION: Be careful not to allow the grease to leak. Do not damage the boot.
  5. Verify that the axle shaft length is within the specification.
Fig 1: Releasing Air From Boot
G00310660Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals