By-Pass Air Solenoid Valve - Millenia 2.3L
WARNING: This page is about a different car, the 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, 2001 Mazda MPV, and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Solenoid valve is located in right rear of engine compartment. To identify solenoid valve, see appropriate illustration in VACUUM DIAGRAMS article. Disconnect vacuum hoses and connector from solenoid valve.
- Apply air pressure to a solenoid valve port. Air should not flow through valve. Using fused jumper wires, apply battery voltage to solenoid valve terminals. Air should flow through valve. Replace solenoid valve as necessary.