LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Controls - System & Component Testing) >> Engine Sensors & Switches >> Camshaft Position (CMP) Sensor >> Protege 2.0L

Protege 2.0L

WARNING: This page is about a different car, the 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, 2001 Mazda MPV, and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect CMP sensor harness connector. CMP sensor is located in timing belt cover, in upper front of engine. Using ohmmeter, measure resistance between component terminals. Resistance should be 950-1250 ohms. Replace as needed. If sensor is okay, check for open or short circuit in Blue wire between CMP sensor 2-pin harness connector and PCM harness connector terminal No. 85. Repair as necessary.

scientia non olet · About LEMON Manuals