LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Removal, Overhaul & Installation >> Air Induction Systems >> Upper Intake Manifold >> Removal & Installation (B4000)

Removal & Installation (B4000)

  1. Disconnect negative battery cable. Remove air cleaner outlet pipe. Disconnect accelerator and cruise control (if equipped) cable(s) from throttle body lever. Remove accelerator cable bracket.
  2. Disconnect harness connectors from Throttle Position (TP) sensor, Idle Air Control (IAC) valve and EGR valve vacuum regulator. Disconnect EGR pipe. Disconnect Power Control Module (PCM) harness connector, wire harness support and ground terminal. Move harness aside.
  3. Disconnect brake booster and vacuum hoses from upper intake manifold and throttle body. Disconnect ignition coil harness connector, right hand secondary ignition wires and unbolt coil. Evenly loosen upper intake manifold nuts. Lift intake manifold and disconnect heated PCV fitting from manifold.
  4. To install, replace upper intake manifold gasket (if necessary). Install upper intake manifold and bolts. Tighten in crisscross pattern to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals