Camshaft Position Sensor (Millenia 2.5L)

Camshaft Position (CMP) sensor is located inside of distributor and is an integrated part. Disconnect distributor 6-pin harness connector. Check for continuity between distributor connector terminals "B" and "D". If continuity is not present, check for open or short between:

• Distributor 6-pin harness connector terminal "B", PCM 34-pin harness connector terminals "4A" and "4C" and main relay terminal "D" (Red/Black wire).
• Distributor 6-pin harness connector terminal "D", PCM 34-pin harness connector terminals "4F" (Pink/Black wire).

Repair wiring harness as necessary. If wiring is okay, replace distributor.