LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.0L >> Bypass Tube >> Removal & Installation

Removal & Installation

  1. Drain the engine Cooling System.
  2. Remove the air cleaner outlet tube.
  3. Disconnect the five hoses from the thermostat housing and remove the thermostat housing.
    Fig 1: Disconnecting Hoses From Thermostat Housing
    G01150896Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the Engine Coolant Temperature (ECT) sensor from the bypass tube.
    Fig 2: Disconnecting ECT Sensor
    G01150897Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolt, stud, and the water bypass tube.
    Fig 3: Removing Water Bypass Tube
    G01150898Courtesy of MAZDA MOTORS CORP.
    6. NOTE: Clean and inspect the sealing surfaces.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals