Removal & Installation (Low Series Console)

1. If equipped, remove the manual transaxle shifter knob by turning counterclockwise. Remove the floor console front finish panel. See Figure .
2. Apply the parking brake. Remove the floor console rear finish panel. See Figure .
3. Remove the floor console front bolts. See Fig 1 .
4. Remove the rear two bolts. Remove the floor console. See Fig 2 .
5. To install, reverse the removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Removing Floor Console Front Bolts

Courtesy of MAZDA MOTORS CORP.

Fig 2: Removing Floor Console Rear Bolts

Courtesy of MAZDA MOTORS CORP.