Brake Pedal Position Switch: Installation

NOTE: Initial installation of BPP switch allows for one adjustment. If additional adjustments are necessary, install a new switch.

NOTE: Numbers in parenthesis refer to numbers in illustration.

1. To unlock, rotate the lock knob counterclockwise to the stop. See Fig 2 .
2. With the engine running fully depress and hold the brake pedal.
3. Install the BPP switch. Position the BPP switch in the bracket and rotate counterclockwise (1). See Fig 3 . Connect the electrical connector (2). See Fig 1 .
4. Slowly release the brake pedal.

Fig 1: Removing Brake Pedal Position Switch

Courtesy of MAZDA MOTORS CORP.

Fig 2: Unlocking Brake Pedal Position Switch

Courtesy of MAZDA MOTORS CORP.

Fig 3: Installing Brake Pedal Position Switch

Courtesy of MAZDA MOTORS CORP.