LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System >> Overhaul >> Brake Master Cylinder >> Disassembly

Brake Master Cylinder: Disassembly

  1. Remove the brake master cylinder. See BRAKE MASTER CYLINDER  under REMOVAL & INSTALLATION.
  2. Clean the outside of the brake master cylinder.
  3. Remove the brake master cylinder reservoir. See Fig 1 .
  4. Remove the seals. See Fig 2 .
  5. Remove the snap ring. See Fig 3 .
  6. Remove the primary and secondary piston. See Fig 4 .
    NOTE: If the brake master cylinder bore is damaged, a new brake master cylinder must be installed.
  7. Use isopropyl alcohol to clean and inspect the brake master cylinder bore for damage.
Fig 1: Removing Master Cylinder Reservoir
G00303090Courtesy of MAZDA MOTORS CORP.
Fig 2: Removing Master Cylinder Seals
G00303091Courtesy of MAZDA MOTORS CORP.
Fig 3: Removing Snap Ring
G00303092Courtesy of MAZDA MOTORS CORP.
Fig 4: Removing Master Cylinder Pistons
G00303093Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals