LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Floor Console - Low Series >> Removal and Installation

Removal and Installation

Fig 1: Removing/Installing Floor Console Front Finish Panel
G01144882Courtesy of MAZDA MOTORS CORP.
  1. Remove the floor console front finish panel.
    1. If equipped, remove the manual transaxle shifter knob by turning counterclockwise.
    2. Remove the floor console front finish panel.
      Fig 2: Removing/Installing Floor Console Rear Finish Panel
      G01144883Courtesy of MAZDA MOTORS CORP.
  2. Remove the floor console rear finish panel.
    1. Apply the parking brake.
    2. Remove the floor console rear finish panel.
      Fig 3: Removing/Installing Floor Console Front Bolts
      G01144884Courtesy of MAZDA MOTORS CORP.
  3. Remove the floor console front bolts.
    Fig 4: Removing/Installing Floor Console
    G01144885Courtesy of MAZDA MOTORS CORP.
  4. Remove the floor console.
    1. Remove the rear two bolts.
    2. Remove the floor console.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals