LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Basic Diagnostic Procedures >> Ignition Checks >> Except B2300, B3000, B4000 & Tribute >> Camshaft Position Sensor (Protege & Protege5)

Camshaft Position Sensor (Protege & Protege5)

  1. Disconnect Camshaft Position (CMP) sensor connector. CMP sensor is located near front of valve cover. Using ohmmeter, measure resistance between CMP sensor connector terminals. Resistance should be 950-1250 ohms. If resistance reading is not as specified, replace CMP sensor.
  2. If sensor is okay, disconnect PCM harness connector and install 104-pin breakout box. See Figure . Check for open or short in following circuits:
    • Between CMP sensor harness connector terminal "A" and PCM harness connector terminal No. 85 (Blue wire).
    • Between CMP sensor harness connector terminal "B" and PCM harness connector terminal No. 86 (Green wire).

    Repair or replace wiring harness as necessary.

scientia non olet · About LEMON Manuals