LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Rear Lamp Assembly >> Removal and Installation

Removal and Installation

Fig 1: Removing Rear Lamp Assembly
G01144941Courtesy of MAZDA MOTORS CORP.
  1. Remove the rear lamp assembly.
    1. Remove the bolts.
    2. Using a flat tipped screwdriver covered with a rag, gently pry the lamp from the edge of the quarter panel at the bottom portion, and then the top portion.
    3. Disconnect the electrical connectors.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals