Front Seat Belt
FRONT SEAT BELT REMOVAL/INSTALLATIONWARNING: Handling the front seat belt (pre-tensioner seat belt) or the side air bag sensor improperly can accidentally deploy the pre-tensioner or the side air bag module, which may seriously injure you. Read SERVICE WARNINGS before handling the front seat belt or working around the B-pillar areas. (See AIR BAG SYSTEM SERVICE WARNINGS.)
NOTE: The side air bag sensor is located in the B-pillar.
CAUTION: The ELR has a spring that will unwind if the retractor's cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor.
1. Disconnect the negative battery cable.
2. Remove the B-pillar lower trim.
3. Remove in the order indicated in the table.
1. Anchor cover
2. Front seat belt
4. Install in the reverse order of removal.