LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Protege SE (CANADA) L4-1.6L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Sensors and Switches - Transmission and Drivetrain >> Sensors and Switches - A/T >> Transmission Speed Sensor >> Service and Repair

Transmission Speed Sensor: Service and Repair

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Disconnect the input/turbine speed sensor connector.





4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor.
Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 69.9 - 95.4 inch lbs.)
7. Connect the input/turbine speed sensor connector.
8. Install the air cleaner component.
9. Connect the negative battery cable.

scientia non olet · About LEMON Manuals