On-Vehicle

Inspection of Resistance





1. Measure the resistances between the following terminals.
^ If any resistances are out of specifications, inspect the ground, then perform the operation and the part inspection.

Inspection of Operation

Note:
- When inspecting the pressure control solenoid, connect the GND connection to the GND terminal (I terminal) of the pressure control solenoid inside the solenoid valve connector.
- Do not apply voltage for more than 3 seconds.








1. Apply B+ to terminal A, B, C, F, or G and battery negative voltage to GND, and verify that a click sound is heard from each solenoid.
^ If the click sound is not heard from each solenoid, replace solenoids.





2. Apply B+ to terminal D and battery negative voltage to terminal I, and verify that a click sound is heard from solenoid.
^ If the "click" is not heard, replace the solenoid valve.