Rear Crankshaft Main Bearing Seal: Service and Repair

REAR OIL SEAL REPLACEMENT [ZM]

1. Remove the flywheel. (MTX)
2. Remove the drive plate. (ATX)





3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.

Rear Oil Seal Removal Note





1. Cut the oil seal lip using a razor.
2. Remove the oil seal using a screwdriver protected with a rag.

Rear Oil Seal Installation Note





1. Apply clean engine oil to the new oil seal lip.
2. Push the oil seal slightly in by hand.
3. Tap the oil seal in evenly using the SSTs.