LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2001 >> Tribute LX, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Master Cylinder Push Rod >> Millenia

Master Cylinder Push Rod: Millenia

  1. With master cylinder removed, remove seal and plate assembly from power brake unit. See Fig 1 . Install power brake unit gasket. Place Adjustment Gauge (49-E043-001A) onto power brake unit and tighten mounting nuts to 87-138 INCH lbs. (9.81-15.6 N.m).
  2. Apply 9.62 psi (19.7 in. Hg) to power brake unit. Measure depth of adjustment gauge rod. See Fig 2 . Rod depth should be .88" (22.4 mm). If rod depth is as specified, no adjustment is necessary. If gauge rod depth is not as specified, using Rod Holder (49-E043-003) and Socket (49-E043-004), adjust power brake push rod as necessary to obtain rod depth of specification.
Fig 1: Removing Master Cylinder (Typical)
G97D08738Courtesy of FORD MOTOR CO.
Fig 2: Measuring Adjustment Gauge Rod Depth
G97F08739Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals