LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2001 >> Tribute LX, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Brake Pedal Height & Stoplight Switch >> Millenia

Brake Pedal Height & Stoplight Switch: Millenia

  1. Remove stoplight switch. Measure length "L". See Figure . Loosen locknut "B", and turn locknut "A" until it does not contact brake pedal. Loosen locknut "D", and turn rod "C" to adjust height. Tighten locknut "D" to 18-25 Ft. Lbs. (24-34 N.m).
  2. Turn locknut "A" so that clearance "M" is .004-.039" (.1-1.0 mm). Tighten locknut "B" to 88-130 INCH Lbs. (9.9-14.7 N.m). Install NEW stoplight switch. Pull brake pedal until tip of stoplight switch clicks. Inspect stoplight operation.
scientia non olet · About LEMON Manuals