LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2001 >> B4000 SE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Removal (4WD With Automatic Locking Hubs)

Removal (4WD With Automatic Locking Hubs)

  1. Raise and support vehicle. Remove front wheel assemblies and caliper. See FRONT DISC BRAKE PADS  . Remove retainer washers from lug nut studs. Remove automatic locking hub assembly from spindle.
    2. NOTE: DO NOT attempt to remove hub lock assembly by prying at hub lock legs. This can result in cracked or broken hub locks, which can cause vacuum leaks.
    Fig 1: Installing Hub Removal Clips & Puller On Wheel Hub (4WD)
    G99E52039Courtesy of MAZDA MOTORS CORP.
  2. Install Hublock Removal Clips and Hub Puller (205-404 & 205-405), and align puller with 3 slots in hub lock. See Fig 1 . Finger tighten set screw. Using an impact slide hammer, remove hub lock. Remove and discard wheel hub "O" ring.
scientia non olet · About LEMON Manuals