LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2001 >> B2500 SX, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels >> Symptom Tests >> Test E: Speedometer/Odometer Inoperative

Test E: Speedometer/Odometer Inoperative

  1. Turn ignition switch to LOCK position. Disconnect instrument cluster 10-pin harness connector C-216. Measure voltage at terminal No. 7 (White/Yellow wire) at instrument cluster harness connector C-216. See Figure. If voltage is greater than 10 volts, go to next step. If voltage is 10 volts or less, repair open in White/Yellow wire between instrument cluster and fuse No. 25 and retest system.
  2. Disconnect instrument cluster connectors C-214 and C-216. Check printed circuit by making measurements at speedometer gauge pins, inside instrument cluster printed circuit clips. See SPEEDOMETER PRINTED CIRCUIT MEASUREMENTS  table. If all resistance readings are less than one ohm, go to next step. If any resistance reading is greater than one ohm, replace instrument cluster printed circuit.
    SPEEDOMETER PRINTED CIRCUIT MEASUREMENTS

    Connector (Terminal) Connector (Terminal No.)
    Speedometer (S) C215 (1)
    Speedometer (G) C215 (2)
    Speedometer (B) C214 (13)
    Batt C216 (7)
  3. Disconnect PCM connector B-111 and install breakout box to harness connector. Leave PCM disconnected. Measure resistance of Gray/Black wire between terminal No. 1 at instrument cluster harness connector C-215 and terminal No. 68 of breakout box. If resistance is 5 ohms or less, replace speedometer. If resistance is greater than 5 ohms, repair open in Gray/Black wire between instrument cluster and breakout box and retest system.
scientia non olet · About LEMON Manuals