LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2000 >> MPV ES >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> 2004-05: MAZDA6 >> Mode 3: 2004 (H02S Heater, H02S & TWC Repair Verification Drive Mode) (3.0L Cal: AJ57EM060AJV5010 (M/T), AJ58EM060AJVN010 (A/T) Only)

Mode 3: 2004 (H02S Heater, H02S & TWC Repair Verification Drive Mode) (3.0L Cal: AJ57EM060AJV5010 (M/T), AJ58EM060AJVN010 (A/T) Only)

  1. Perform "PCM Adaptive Memory Produce Drive Mode" first.
  2. Verify that all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
  3. Drive the vehicle as shown in the graph. The driving condition before driving at constant speed is not specified.
  4. Stop the vehicle and access the ON BOARD SYSTEM READINESS menu of GENERIC OBDII FUNCTION to verify the OBD monitoring status.
    • If completed, the OBD monitoring status items change from non-completed to completed.
    • If not completed, turn the ignition switch off, then repeat from Step 3.
  5. Access the DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD-II FUNCTIONS to verify the monitor results.
    • If the detected values are not within the specification, the repair has not been completed.
    Fig 1: Vehicle Drive Graph (Mode 3)
    G01024722Courtesy of MAZDA MOTORS CORP.
  6. Verify that no DTCs are available.
scientia non olet · About LEMON Manuals