Fuel Gauge Sending Unit
CAUTION:
Relieve fuel pressure before servicing fuel system. See appropriate BASIC DIAGNOSTIC PROCEDURES article in ENGINE PERFORMANCE.
- Remove fuel gauge sending unit. Connect ohmmeter between wire terminals "A" and "B" of fuel gauge sending unit connector.
- Measure resistance with fuel gauge sending unit float in specified position. See FUEL GAUGE SENDING UNIT RESISTANCE table. If resistance is not as specified, replace fuel gauge sending unit.
FUEL GAUGE SENDING UNIT RESISTANCE
| Float Position | (1) Ohms | ||||
|---|---|---|---|---|---|
| Fully Raised | 18-20 | ||||
| Fully Lowered | 119-121 | ||||
|
|||||