LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2000 >> MPV ES >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Overhaul - GF4A-El >> Performance Tests >> Road Test Procedure >> "2", "1" & "P" Position Tests (MPV & 626)

"2", "1" & "P" Position Tests (MPV & 626)

  1. Shift selector lever to "2" position. Accelerate vehicle at half throttle and WOT. Verify 2nd gear is held. Decelerate vehicle and verify engine braking effect is felt. On 626 equipped with Traction Control System (TCS), engine braking effect should be felt in 2nd gear.
  2. Shift selector lever to "1" position. Accelerate vehicle at half throttle and WOT. Verify 1st gear is held. Decelerate vehicle and verify engine braking effect is felt.
  3. Shift into "P" position on a gentle slope. Release brake. Ensure vehicle does not roll.
scientia non olet · About LEMON Manuals