LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2000 >> MPV DX >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> 2004-05: MAZDA6 >> Mode 3: 2004 (H02S Heater, H02S & TWC Repair Verification Drive Mode) (2.3L & 3.0L Cal: Except For AJ57EM060AJV5010 (M/T), AJ58EM060AJVN010 (A/T)): 2005 All Engines

Mode 3: 2004 (H02S Heater, H02S & TWC Repair Verification Drive Mode) (2.3L & 3.0L Cal: Except For AJ57EM060AJV5010 (M/T), AJ58EM060AJVN010 (A/T)): 2005 All Engines

  1. Perform "PCM Adaptive Memory Production Drive Mode" first.
  2. Verify all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
  3. Drive the vehicle as shown in the graph. The driving conditions before driving at constant speed are not specified.
    Fig 1: Vehicle Drive Graph (Mode 3)
    G01024723Courtesy of MAZDA MOTORS CORP.
  4. Stop the vehicle and access the ON BOARD SYSTEM READINESS menu of GENERIC OBD-II FUNCTION to verify the OBD monitoring status.
    • If completed, the OBD monitoring status items change from non-completed to completed.
    • If not completed, turn the ignition switch off, then repeat from Step 3.
  5. Access the DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD-II FUNCTIONS to verify the monitor results.
    • If the detected values are not within the specification, the repair has not been completed.
  6. Verify no DTCs are available.
scientia non olet · About LEMON Manuals