Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the B3000 SE, 2D Pickup, 4WD, Automatic, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,w/Rear Drum Brakes | 2.2 | B | ||
| Front | 1.0 | B | ||
| Rear,w/Drum Brakes | 1.4 | B | ||
| Combination Procedure: CALIPER: Overhaul: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.9 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.7 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| 4WD, Front,Each Side | 0.8 | B | ||
| Combination Procedure: WHEEL CYLINDER: Overhaul: | ||||
| One,Off Vehicle,w/ABS | 0.9 | B | ||
| One,Off Vehicle,w/o ABS | 0.4 | B | ||
| One,On Vehicle,w/ABS | 0.7 | B | ||
| One,On Vehicle,w/o ABS | 0.3 | B | ||
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One,w/ABS | 0.7 | B | ||
| One,w/o ABS | 0.3 | B | ||
| Combination Procedure: WHEEL SEAL: Replace: | ||||
| Rear,Each Side | 0.6 | B | ||