Temperature Gauge Test: Millenia
- Remove instrument cluster. Connect battery positive voltage to terminal 2G (Black/Yellow wire) terminal of instrument cluster and ground terminal 2I (Brown/Red wire). See Figure
. Connect Red wire of Checker (49-0839-285) to terminal 2E (Green wire) of instrument cluster. Connect checker Black wire to ground.
- Set checker to specified resistance value. See TEMPERATURE GAUGE RESISTANCE (MILLENIA) table. If temperature gauge needle does not rests at specified position for each resistance value setting, replace temperature gauge.
TEMPERATURE GAUGE RESISTANCE
| Checker Resistance Setting (Ohms) |
Needle Position |
| 153 |
Cold |
| 19 |
Hot |