LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1998 >> B2500 SX, Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Self-Diagnostics >> Accessing Parameter Identification (PID) Information

Accessing Parameter Identification (PID) Information

Turn ignition switch to LOCK position. Connect New Generation Star (NGS) tester to data link connector. Enter vehicle information on NGS tester. After all vehicle options are selected, press SAVE key. Select DIAGNOSTIC DATA LINK TEST, then select GEM - GENERIC ELECTRONIC MODULE on NGS tester. Enter appropriate vehicle options on NGS tester. Select PID/DATA MONITOR AND RECORD. Move cursor on NGS tester to desired PID and press TRIGGER key. To retrieve that PID information, press START key on NGS tester.

GENERIC ELECTRONIC MODULE (GEM) DTC IDENTIFICATION

DTC (1) Description Perform Test
B1322 Left Front Door Ajar Switch Circuit Short To Ground (2)(3) W
B1323 Door Ajar Light Circuit Failure W
B1325 Door Ajar Light Circuit Short To Voltage W
B1330 Right Front Door Ajar Circuit Short To Ground (3) W
B1426 Seat Belt Light Circuit Short To Voltage X
B1428 Seat Belt Light Circuit Failure X
B1462 Seat Belt Switch Circuit Failure (3) X
C1751 Vehicle Speed Sensor Output Short To Voltage F
C1752 Vehicle Speed Sensor Output Short To Ground F
P0500 Vehicle Speed Signal Circuit Failure (4) F
P1804 4WD High Indicator Circuit Failure Y
P1806 4WD High Indicator Circuit Short To Voltage Y
P1808 4WD Low Indicator Circuit Failure Y
P1810 4WD Low Indicator Circuit Short To Voltage Y
(1) Testing for DTCs not listed, see appropriate MODULE COMMUNICATIONS NETWORK article.
(2) Test interior light wiring for opens and/or shorts and repair as necessary. See appropriate wiring diagram in ILLUMINATION/INTERIOR LIGHTS article.
(3) Perform wiggle test. See WIGGLE TEST under SELF-DIAGNOSTIC SYSTEM in appropriate MODULE COMMUNICATIONS NETWORK article.
(4) See appropriate WIPER/WASHER SYSTEMS article for additional testing procedures.
SYMPTOM CHART

Symptom Go To Test
Fuel Gauge Inaccurate A
Coolant Temperature Gauge Inaccurate B
Oil Pressure Gauge Inaccurate C
Speedometer Inaccurate D
Speedometer/Odometer Inoperative (With 4-Wheel ABS) E
Speedometer/Odometer Inoperative (With Rear ABS) F
Tachometer Inoperative G
Tachometer Inaccurate H
Charge Indicator Always/Never On J
Anti-Lock Brake Warning Light Inoperative K
Fuel Reset Light Inoperative L
High Beam Indicator Inoperative M
Check Engine Light Inoperative N
Turn Indicator Inoperative P
Overdrive (O/D) Off Indicator Inoperative Q
Cruise Control Indicator Never/Always On R
Brake Warning Light Inoperative S
Check Gauges Indicator Inoperative T
No Communication With GEM U
Air Bag Indicator Inoperative V
Door Ajar Indicator Inoperative W
Seat Belt Warning Indicator Inoperative X
4WD High, 4WD Low Indicator Inoperative Y