LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1998 >> B2500 SX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Removal (4WD With Automatic Locking Hubs)

Removal (4WD With Automatic Locking Hubs)

  1. Raise and support vehicle. Remove front wheel assemblies and caliper. See FRONT DISC BRAKE PADS. Remove retainer washers from lug nut studs. Remove automatic locking hub assembly from spindle.
  2. Remove snap ring from end of spindle shaft. Remove axle spacers. See Figure . Carefully pull cam assembly off wheel bearing adjusting nut. If necessary, rotate adjusting nut slightly to relieve pressure on locking key.
  3. Using a magnet, remove locking key. Using 2 3/8" Hex Lock Nut Wrench (49-UN01-037), remove wheel bearing adjusting nut. Remove outer wheel bearing and rotor.
scientia non olet · About LEMON Manuals