Removal & Installation (Millenia, MPV, Protege & 626)
- Raise and support vehicle. Remove rear wheel assemblies. Remove rear brake caliper with brake hose connected. See REAR BRAKE CALIPER . Support caliper using wire. Remove rotor-to-hub screws (if equipped). Remove rotor.
- Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS table.
- To install, reverse removal procedure. Check end play at grease cap. On 1997, if end play exceeds 0.002" (0.05 mm), check lock nut torque or replace wheel bearings.