All Warning Lights Do Not Illuminate With Key On
- Check METER fuse (10-amp). If METER fuse is okay, go to next step. If METER fuse is blown, repair wiring and replace fuse.
- Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Measure voltage between ground and instrument cluster harness connector No. 3 terminal 3N. See Figure . If battery voltage is present, replace Instrument Cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. If battery voltage is not present, repair wiring between METER fuse (10-amp) and instrument cluster. See WIRING DIAGRAMS.